Caravan V6-201 3.3L (1995)
Keyless Entry Module: Service and Repair
Programming Module
PROGRAMMING RKE MODULE
The RKE module is capable of retaining up to 4 different VAC(s) when vehicle battery power is interrupted. Replacement or additional key fob
transmitter VAC(s) (maximum 4) can be programmed into the Body Control Module (BCM). A functional key fob transmitter is required to program
the BCM to accept the new VAC. If a functional key fob transmitter is not available, a scan tool (DRB) can be used to program the BCM.
(1) Using a functional key fob, unlock the vehicle and disarm the Vehicle Theft Alarm
(2) Insert ignition key into the ignition switch.
(3) Switch ignition to RUN position without starting engine.
(4) On a functional key fob, actuate and hold the UNLOCK button for a minimum four seconds (maximum ten seconds).
(5) While holding UNLOCK button, and before ten seconds passes, actuate and release the PANIC button. A single chime will sound to verify that the
RKE module is set to receive the new VAC.
(6) Within 30 seconds of the chime, actuate any key on each new key fob transmitter. After 30 seconds or when ignition switch is turned OF{ the RKE
module will end the programming mode. A single chime will sound to verify that the RKE module will no longer receive additional VAC(s).
(7) When VAC programming is complete, turn OFF ignition switch and verify RKE system operation using each key fob.
NOTE: Only the primary (first two) key fob transmitters will operate the memory seat and mirror systems. If a primary key fob is being replaced, the
memory seat and mirror module will require programming. Refer to Group 8R, Power Seats for proper (data link) programming procedure.
