dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Recall - Inadvertent Airbag Deployment|Page 8488 > < Recall - Inadvertent Airbag Deployment|Page 8486
Page 8
background image

25.

If the airbag system has one or more of the three DTC's in the table, proceed as shown in the table. If no airbag system DTC's exist, continue with
Step 26.

NOTE

Refer to the appropriate Diagnostic Manual for the proper diagnostic and repair procedures on any airbag system diagnostic trouble codes other than
those listed above.

26.

Install the lower steering column cover (Figure 1).

27.

Connect the parking hand brake linkage.

28.

Connect the liftgate release switch electrical connector (Figure 1).

29.

Tighten the lower steering column cover screws securely.

30.

Return the vehicle to the customer. No further action is necessary.

B. Replace Rear Wiper Motor

IMPORTANT

This section is only for vehicles with a "Loss of Ignition Run Only" diagnostic trouble code.

1.

With the ignition switch in the OFF position, disconnect the negative battery cable.

NOTE

To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.

2.

Remove the liftgate wiper arm assembly.

3.

Open and raise the liftgate.

4.

Remove the two (2) speaker grille/courtesy lamp assemblies (Figure 3).

Recall - Inadvertent Airbag Deployment|Page 8488 > < Recall - Inadvertent Airbag Deployment|Page 8486