Caravan V6-201 3.3L (1995)
24.
In the fuse block located under the instrument panel, replace the rear wiper motor/airbag fuse (Fuse # 13) with a new 20 amp fuse (Figure 5).
25.
^
If any other airbag system diagnostic trouble codes were detected and must be still be repaired, continue with the appropriate section of the
Service Procedure to correct that issue.
^
If no other diagnostic trouble codes require correction, continue with Step 26.
26.
Install the lower steering column cover (Figure 1).
27.
Connect the parking hand brake linkage.
28.
Connect the liftgate release switch electrical connector (Figure 1).
29.
Tighten the lower steering column cover screws securely.
30.
Turn the ignition switch to the ON position and exit the vehicle.
31.
Connect the negative battery terminal.
32.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then back to the ON position.
33.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures manual
to diagnose and repair the problem.
C. Repair Driver Airbag Wiring and.or Replace Clockspring
IMPORTANT:
This section is only for vehicles with a "Driver Squib Term Shorted to Ground" diagnostic trouble code.
1.
Place the steering wheel in the straight ahead position.
2.
With the ignition switch in the OFF position, disconnect the negative battery cable.
NOTE:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.
3.
Remove the upper and lower steering column shrouds.
