Caravan V6-201 3.3L (1995)
6.
Inspect the I/P wiring harness where it is routed past the brake pedal support to verify that the harness tie strap/clip is secured into the hole (Figure
7).
^
If the tie strap/clip is on the harness but not in the hole, inspect the wiring harness for damage. Any chafed or cut wires should be repaired per
the Wiring Repair Procedure.
^
If the tie strap/clip is missing or damaged, install a new tie strap/clip (P/N 05016944AA) and insert the clip into the hole.
7.
Install another mastic patch on the edge of the brake pedal support bracket to prevent damage to the I/P wiring harness as it routes up past the fuse
block (Figure 7).
8.
Remove the relay access cover.
9.
Inspect the I/P wiring harness and verify that the harness tie strap/clip has been inserted into the tab off of the fuse/relay/kneeblocker bracket
(Figure 8).
^
If the clip is on the harness but not in the hole, inspect the wiring harness for damage. Any chafed or cut wires should be repaired per the
Wiring Repair Procedure.
^
If the tie strap/clip is missing or damaged, install a new tie strap/clip (P/N 0516944AA) and insert the clip into the hole.
10.
Install another mastic patch to the outboard end of the steel tube that routes the transmission shifter cable and the steering column support bracket
closest to the I/P wiring harness (Figure 8).
11.
Install the relay access cover.
