Caravan V6-201 3.3L (1995)
Fig. 5 Shim Installation For Positive Camber (FWD)
Fig. 6 Shim Installation For Negative Camber (FWD)
Alignment adjustment is made by adding .010 inch shims between spindle mounting surface and axle casting. Each shim equals wheel change by 0.3.°
When recording rear toe-in (vehicle backed onto alignment rack) remember to reverse sign convention. Install alignment shims as follows;
1. Raise and support vehicle, then remove wheel.
2. Remove brake drum, then loosen four brake assembly and spindle mounting bolts enough to allow clearance for shim installation. Do not remove
mounting bolts.
3. Install shims as shown. No more than 2 shims on each spindle should be used to bring alignment within acceptable range.
