Caravan V6-201 3.3L (1995)
Steering Gear: Service and Repair
FWD
1. Raise and support vehicle, then remove front wheels.
2. Remove tie rod ends using a suitable puller.
3. Remove splash shields and boot seal shields, then fluid lines to pump on power steering gear only.
4. Disconnect tie rod ends from steering knuckles.
5. Remove crossmember to steering gear attaching bolts, then steering gear from left side of vehicle.
6. Reverse procedure to install, noting following:
a. For manual gear, make sure master serrations are inline.
b. Right rear crossmember bolt is a pilot bolt that correctly locates crossmember. Tighten this bolt first. Tighten all four crossmember bolts to
specifications. Proper torque is very important.
c. Tighten four bolts attaching steering gear to crossmember to specifications.
