Caravan V6-201 3.3L (1995)
21.
Install another mastic patch over the rear corner and left edge of the Body Control Module (BCM) (Figure 10).
22.
Install the console assembly.
23.
Install the upper console attaching screws behind the cupholder. Tighten the screws securely. Close the cupholder.
24.
Install the two (2) lower console attaching screws (Figure 9). Tighten the screws securely.
25.
^
If any other airbag system diagnostic trouble codes were detected and must still be repaired, continue with the appropriate section of the
Service Procedure to correct that issue.
^
If no other diagnostic trouble codes require correction, continue with Step 26.
26.
Turn the ignition switch to the ON position and exit the vehicle.
27.
Connect the negative battery terminal.
28.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then back to the ON position.
29.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures manual
to diagnose and repair the problem.
D. Repair Passenger Airbag Wiring
IMPORTANT:
This section is only for vehicles with a "Passenger Squib Term Shorted to Ground" diagnostic trouble code.
1.
With the ignition switch in the OFF position, disconnect the negative battery cable.
NOTE:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.
2.
Remove the two (2) screws that attach the lower console to the instrument panel support brackets (Figure 11).
3.
Slide the cupholder out.
4.
Remove the two (2) upper console attaching screws behind the cupholder (Figure 11).
5.
Slide the console rearward and up to remove.
