Caravan V6-201 3.3L (1995)
6.
Inspect the I/P wiring harness where it connects to the Airbag Electronic Control Module (AECM) (Figure 12). Any chafed or cut wires should be
repaired per the Wiring Repair Procedure.
7.
Install a mastic patch over the rear corner and left edge of the Body Control Module (BCM) (Figure 12).
8.
Inspect the I/P wiring harness above the AECM and the BCM. Verify that the clip on the harness is installed into the hole on the back side of the
left center console bracket (Figure 12).
^
If the clip is on the harness but not in the hole, inspect the wiring harness for damage. Any chafed or cut wires should be repaired per the
Wiring Repair Procedure.
^
If the clip is missing or is damaged, install a new tie strap/clip (P/N 05016944AA) and insert the clip into the hole.
9.
Install the console assembly.
10.
Install the upper console attaching screws behind the cupholder. Tighten the screws securely (Figure 11). Close the cupholder.
11.
Install the two (2) lower console attaching screws (Figure 11). Tighten the screws securely.
12.
Disconnect the glove box door check straps and allow the door to open fully.
13.
Working through the glove box opening, remove the four (4) screws that attach the passenger airbag module to the I/P bracket (Figure 13).
