Caravan V6-201 3.3L (1995)
18.
Inspect the passenger airbag module takeout on the I/P wiring harness near the vertical support bracket attached to the lip support tube (Figure 16).
Any chafed or cut wires should be repaired per the Wiring Repair Procedure.
19.
Install a mastic patch on the bottom edge of the support bracket just below the existing plastic edge cover (Figure 16).
20.
Install the passenger airbag module into the I/P. Tighten the module attaching screws to 50 in-lbs (6 Nm)
21.
Connect the glove box door check straps and then close the glove box door.
22.
^
If any other airbag system diagnostic trouble codes were detected and must still be repaired, continue with the appropriate section of the
Service Procedure to correct that issue.
^
If no other diagnostic trouble codes require correction, continue with Step 23.
23.
Install the lower steering column cover (Figure 1).
24.
Connect the parking hand brake linkage (Figure 1).
25.
Connect the liftgate release switch electrical connector (Figure 1).
26.
Tighten the lower steering column cover screws securely.
27.
Turn the ignition switch to the ON position and exit the vehicle.
28.
Connect the negative battery terminal.
29.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then back to the ON position.
30.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures manual
to diagnose and repair the problem.
Wiring Repair Procedure
IMPORTANT:
If airbag system wiring is found chafed or damaged, the wiring should be repaired using the procedure listed below.
^
If the plastic wire covering is chafed but the wiring strands are NOT damaged:
Tape the damaged area with high quality electrical tape.
^
If the plastic wire covering is chafed and the wiring strands are damaged:
