Caravan V6-3.3L VIN R (2003)
19.
Position the upper half of the evaporator housing onto the lower half. Be certain that the rubber grommet and the HVAC wire harness take out for
the evaporator temperature sensor are captured in the notched area between the upper and lower housing halves.
20.
Install and tighten the twelve screws around the perimeter of the evaporator housing that secure the upper housing half to the lower half. Tighten
the screws to 2 Nm (18 in. lbs.).
21.
Position the upper half of the recirculation air door onto the lower half of the door.
22.
Install and tighten the two screws that secure the upper half of the recirculation air door to the lower half of the door. Tighten the screws to 2 Nm
(18 in. lbs.).
23.
Position the upper intake air housing onto the top of the evaporator housing over the recirculation air door and the blower wheel housing. Be
certain that the upper pivot of the recirculation air door is captured in the pivot receptacle of the upper intake air housing.
24.
Install and tighten the three screws that secure the upper intake air housing to the top of the outboard end of the evaporator housing. Be certain not
to miss the screw located just inside the inboard side of the fresh air intake opening. Tighten the screws to 2 Nm (18 in. lbs.).
25.
Install and tighten the two screws that secure the upper intake air housing to the lower intake air housing. Tighten the screws to 2 Nm (18 in. lbs.).
26.
Engage the two hook formations on the bottom of the distribution housing in the two receptacles on the evaporator housing.
27.
Roll the top of the distribution housing up into position against the evaporator housing.
28.
Install and tighten the three screws from the dash panel side of the unit that secure the top of the distribution housing to the inboard end of the
evaporator housing. Tighten the screws to 2 Nm (18 in. lbs.).
29.
Engage the HVAC wire harness in the routing clips molded into the outside of the HVAC housing components.
30.
Connect the HVAC wire harness connector for the blower motor with the motor connector receptacle on the bottom of the outboard end of the
evaporator housing.
31.
Install the expansion valve onto the evaporator inlet and outlet tube fittings.
32.
Install a new foam seal from the NC Heater unit seal kit (p/n 05019220AD) onto the HVAC housing seal flange around the fresh air inlet opening
and the expansion valve/evaporator tube opening on the dash panel side of the unit.
33.
Install the heater core tubes into the heater core.
