Caravan AWD V6-201 3.3L (1991)
7. Remove wheel bearing mounting bolts.
8. Remove wheel bearing and hub assembly.
9. Replacement of the grease seal is recommended whenever this service is performed.
INSTALLATION
1. Install new hub and bearing assembly and tighten screws in a criss-cross pattern to 130 Nm (96 ft.lbs.).
CAUTION: Knuckle and bearing mounting surfaces must be smooth and completely free of foreign material or nicks.
2. Use special tool No. 6536-A to install seal if seal replacement is required.
CAUTION: During any service procedures where knuckle and half shaft are separated, thoroughly clean seal and wear sleeve and lubricate both
components.
3. Lubricate the full circumference of the seal (and wear sleeve) with Multi-Purpose Lubricant.
4. Install washer and hub nut after cleaning foreign matter from threads.
5. With brakes applied, tighten nut to 244 Nm (180 ft.lbs.).
6. Install spring washer, nut lock and new cotter pin. Wrap cotter pin prongs tightly around nut lock.
7. Install wheel and tire assembly. Tighten wheel nuts to 115 Nm (85 ft.lbs.).
