Caravan AWD V6-201 3.3L (1991)
completely release bearing preload. Finger tighten adjusting nut.
14.
Position nut lock with one pair of slots in line with cotter pin hole. Install cotter pin. The end play should be .025-mm. (.001-.003 in.). Clean and
install grease cap.
15.
Install wheel and tire assembly. Tighten wheel nut to 129 N-m (95 ft.lbs.) torque.
16.
Lower vehicle.
17.
Recheck alignment specifications.
The Chrysler Corporation recommended rear wheel specifications are:
(FOR PRIOR MODELS REFER TO APPLICABLE SERVICE MANUALS FOR SPECIFICATIONS)
POLICY:
Information only.
Technical Service Bulletin # 020790
Date: 901105
Rear Wheel Alignment - Uneven Tire Wear
NO.: 02-07-90
GROUP:
SUSPENSION
DATE:
Nov. 5, 1990
SUBJECT:
Rear Tire Noise And Wear/Rear Wheel Aligriment
MODELS:
1989-1991 All Domestic FWD Vehicles (Excluding BB - Monaco)
SYMPTOM/CONDITION:
Rear camber and/or toe alignment causing uneven tire wear or excessive tread noise.
DIAGNOSIS:
If rear alignment is required, place vehicle on alignment rack and check alignrnent specifications. Two or four wheel alignment racks are acceptable,
following manufacturers instructions. Re-(2 wheel alignment rack) when recording rear toe-in (vehicle backed onto alignment rack) REMEMBER to
reverse sign convention; a total toein on direct reading charts is actually toe-out while driving. Maintain rear alignment within Chrysler Corporation
recommendations/specifications.
PARTS REQUIRED:
1 or 2 Shims
PN 5205114 (except AC, AY and AS Bodies)
1 or 2 Shims
PN 4626165 (all carlines)
