Caravan FWD L4-2.4L VIN B (1998)
Power Steering Pump Adjustment
1. From on top of the vehicle loosen locking nuts D and F.
2. From under the vehicle loosen the pivot bolt E. Loosen adjusting bolt G until belt can be removed.
3. After installing a new belt, adjust belt tension by tightening the adjusting bolt until the proper tension obtained. Refer to tension specification in
Belt Tension Chart.
4. Tighten locking nuts D and F to 54 Nm (40 ft. lbs.).
5. Tighten pivot bolt E to 54 Nm (40 ft. lbs.)
Power Steering Belt
GENERATOR AND AIR CONDITIONING
Air Conditioning Compressor/Generator Belts 2.4L
1. Loosen lower generator pivot bolt and upper locking nut, then loosen adjusting bolt to remove belt tension.
CAUTION: Belt damage may occur if the following procedure is not performed.
2. Tighten lock nut to 21 Nm (180 inch lbs.) and torque generator pivot bolt to 54 Nm (40 ft. lbs.). To assure proper alignment of generator
assembly. Adjust belt tension by tightening the adjusting bolt until proper belt tension is obtained. Refer to tension specification in Belt Tension
Chart.
3. Torque lock nut to 54 Nm (40 ft. lbs.).
