Caravan FWD L4-2.4L VIN X (1997)
Front Brake Shoe Assembly Identification
NOTE: The inboard and outboard brake pads are not common, refer to above image for inboard and outboard brake pad assembly identification.
Inboard Brake Shoe
3. Install the new inboard brake pad assembly into the caliper piston by firmly pressing into piston bore. Be sure inboard brake pad assembly is
positioned squarely against face of caliper piston.
Installing Outboard Brake Shoe
4. Slide the new outboard brake pad assembly onto the caliper assembly.
5. Install brake caliper.
Cleaning and Inspection
If a visual inspection does not adequately determine the condition of the lining, a physical check will be necessary. To check the amount of lining wear,
remove the wheel and tire assemblies, and the calipers. Remove the shoe and lining assemblies. Combined shoe and lining thickness should be measured
at the thinnest part of the brake shoe assembly. When a shoe and lining assembly is worn to a thickness of approximately 7.95 mm (0.313 inch) it should
