Caravan FWD L4-2.4L VIN X (1997)
12. Install the wheel speed sensor on the hub/ bearing and adapter. Install the wheel speed sensor attaching bolt. Tighten the wheel speed sensor
attaching bolt to a torque of 12 Nm (9 ft. lbs).
13. Install the parking brake cable into its mounting hole in the adapter. Be sure all the locking tabs on the parking brake cable retainer are expanded
out to ensure the cable will not pull out of the adapter.
Park Brake Cable Attachment To Actuator
14. Install the end of the parking brake cable on the parking brake actuator lever.
NOTE: The horseshoe clip must be installed and installed properly when the parking brake cable is installed in the adapter. Purposed of
horseshoe clip is to prevent parking brake cable retainer from moving in the adapter. If horseshoe clip is not installed parking brake cable retainer
will rattle in the adapter.
15. Install a NEW horseshoe clip on the parking brake cable retainer. The horseshoe clip is installed between the retainer for the parking brake cable
and the adapter. Horseshoe clip must be installed with the curved end of the clip pointing straight up and the edge of the curved end facing toward
the rear of the vehicle.
Locking Out Automatic Adjuster
16. Remove the locking pliers from the front parking brake cable.
17. Install the rotor on the hub/bearing.
