Caravan FWD L4-2.4L VIN X (1997)
2.
Connect the DRBIII scan tool to the vehicle diagnostic connector and turn the ignition key to the ON position.
3.
Using the DRBIII, check for Airbag System Diagnostic Trouble Codes (DTC).
>
If the DTC "DRIVER SQUIB CIRCUIT OPEN" is present (either active or stored), the clockspring assembly MUST be replaced. Erase the
DTC and continue with Step 4.
>
If there are no DTC's or if any other airbag system DTC is present, the recall service procedure does not apply. Diagnosis and repairs are the
owner's responsibility.
4.
Place the front wheels in the straight-ahead position.
5.
Disconnect the negative battery cable.
NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
6.
From the backside of the steering wheel, remove the three (3) screws that secure the driver's airbag module to the steering wheel (Figure 1).
7.
Pull the airbag module away from the steering wheel far enough to access the wire harness connectors on the back of the airbag module.
8.
Disconnect the clockspring horn switch wire harness connector from the horn switch wire connector on the back of the airbag module (Figure 2).
9.
Disconnect the clockspring airbag wire harness connector (Figure 2) from the back of the airbag module by firmly grasping and pulling, or gently
prying, the connector.
NOTE:
Do NOT pull on the clockspring wire harness to disengage the connector from the airbag module connector receptacle.
10.
Disconnect the clockspring wire harness connectors from the speed control switches (if equipped) (Figure 2).
