Caravan FWD L4-2.4L VIN X (1997)
10. Install the power steering fluid return hose on the steel tube at the front suspension cradle.
11. Install a screw type hose clamp on the power steering hose to steel tube connection. Be sure hose clamps are properly reinstalled. Tighten the screw
clamp to a torque of 2 Nm (18 inch lbs.).
CAUTION: The protective heat shield sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering
fluid pressure and return hoses. This is required to prevent the overheating of the power steering hoses.
12. When used, properly position the protective heat sleeves on the power steering hoses. Then, tie strap the heat sleeves to the power steering hoses to
keep them in their proper position.
13. Install the exhaust pipe on the exhaust manifold. Install all exhaust system hangers/isolators on the exhaust system brackets.
14. Connect the oxygen sensor wiring harness to the vehicle wiring harness. Install wiring harness grommet in the floor pan of the vehicle.
15. Lower vehicle.
16. Adjust the power steering pump drive belt. Refer to Engine.
17. Tighten the top nut and bottom bolt on the power steering pump front mounting bracket to a torque of 54 Nm (40 ft. lbs.).
CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar (R), Power Steering Fluid, or equivalent.
18. Fill the remote power steering pump fluid reservoir to correct fluid level.
19. Install cap on power steering fluid reservoir.
20. Connect the negative battery cable on the negative battery post.
21. Start engine and turn steering wheel several times from stop to stop to bleed air from fluid in system. Stop engine, check fluid level, and inspect
system for leaks.
Removal
WARNING: Power steering oil, engine components and the exhaust system may be extremely hot if engine has been running.
