Caravan FWD V6-201 3.3L (1992)
Ball Joint: Service and Repair
BALL JOINT REMOVAL
(1) Pry off seal.
(2) Position Receiving Cup Tool C-4699-2 to support lower control arm while receiving ball joint assembly.
(3) Install 1-1/16 inch deep socket over ball joint stud and against the ball joint upper housing.
(4) Press down against the ball joint upper housing, to remove ball joint assembly from lower control arm.
BALL JOINT INSTALLATION
(1) By hand, position ball joint assembly into the ball joint bore of the lower control arm. Be sure the ball joint assembly is not cocked in the bore of
the control arm, this will cause binding of the ball assembly.
(2) Position assembly in press with Installer Tool 1C-4699-1 supporting control arm.
