Caravan FWD V6-201 3.3L (1992)
(3) Install the Receiver Cup, Special Tool C-4699-2 -over the ball joint stud and down on the lower control arm assembly.
(4) Carefully align all pieces. Using an arbor press apply pressure against the control arm assembly, until ball joint is fully seated against bottom
surface of control arm. Do not apply excessive pressure against the control arm.
BALL JOINT SEAL INSTALLATION
(1) Support ball joint housing with Installer, Special Tool C-4699-1. Position new seal over ball joint stud and against ball joint housing.
(2) With 1-1/2 inch socket, press seal onto ball joint housing until it is squarely seated against top surface of control arm as shown.
