dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Power Door Lock Actuator|Service and Repair > < Driver Door Lock Motor Connector|Page 9065
Page 2
background image

operating the door lock switch. In the event that none of the motors work, the problem may be caused by a shorted motor, a relay or a bad switch.
Disconnecting the defective motor will allow the others to work.

To test an individual door lock motor, disconnect the electrical connector from the motor. To lock the door, connect a 12 Volt power source to the
positive pin of the lock motor and a ground wire to the other pin. To unlock the door reverse the wire connections at the motor pin terminals. If these
results are NOT obtained, replace the motor.

Power Door Lock Actuator|Service and Repair > < Driver Door Lock Motor Connector|Page 9065