Caravan FWD V6-201 3.3L VIN R MFI (1997)
Brake Master Cylinder: Service and Repair
Master Cylinder Bleeding
Bench Bleeding
The content of this article reflects changes called for in TSB 26-12-96.
CAUTION: When clamping master cylinder in vise, only clamp master cylinder by its mounting flange, do not clamp on primary piston, seal/boot or
body of master cylinder.
Master Cylinder Mounted In Vise
1. Clamp the master cylinder in a vise using only the mounting flange.
Bleed Tubes Installed On Master Cylinder
NOTE: Two different size bleeding tubes are used depending on which type of master cylinder the vehicle is equipped with. Vehicles equipped with
traction control use a center port master cylinder with a larger diameter brake tube. Vehicles not equipped with traction control use a compensating
port master cylinder using a standard 3/16" diameter brake tube. Be sure the correct size bleeding tubes are used when bleeding the master cylinder.
2. Install the Bleeding Tubes, Special Tool 6920 for a non traction control master cylinder or Special Tool 8129 for a traction control master cylinder
on the master cylinder. Position bleeding tubes so the outlets of bleeding tubes will be below surface of brake fluid when reservoir is filled to its
proper level.
3. Fill brake fluid reservoir with brake fluid conforming to DOT 3 specifications such as Mopar or an Equivalent.
4. Using a wooden dowel, depress push rod slowly, and then allow pistons to return to released position. Repeat several times until all air bubbles are
expelled from master cylinder.
5. Remove bleeding tubes from master cylinder outlet ports, and then plug outlet ports and install fill cap on reservoir.
6. Remove master cylinder from vise.
7. Install the filler cap from the master cylinder filler neck, on the master cylinder fluid reservoir.
8. Install the master cylinder assembly on the power brake vacuum booster.
