Caravan FWD V6-201 3.3L VIN R MFI (1997)
5. Install the wheel speed sensor to steering knuckle attaching bolt. Tighten the speed sensor attaching bolt to a torque of 12 Nm (105 inch lbs.).
6. Check the air gap between the face of the wheel speed sensor and the top surface of the tonewheel. Air gap must be less then the maximum
allowable tolerance of 1.2 mm (0.047 inch).
7. Install the wheel and tire assembly on vehicle.
8. Road test vehicle to ensure proper operation of the base and ABS brake systems.
Removal
PROCEDURE
1. Raise vehicle on jack stands or centered on a frame contact type hoist.
2. Remove the tire and wheel assembly from the vehicle.
CAUTION: When unplugging speed sensor cable from vehicle wiring harness be careful not to damage pins on the electrical connectors. Also
inspect connectors for any signs of previous damage.
3. Remove grommet from floor pan of vehicle and unplug speed sensor cable connector from vehicle wiring harness.
CAUTION: When removing rear wheel speed sensor cable from routing clips on rear brake flex hose, be sure not to damage the routing clips.
Routing clips are molded onto the hose and will require replacement of the brake flex hose if damaged during removal of the speed sensor cable.
Speed Sensor Cable Attachment To Brake Flex Hose
4. Carefully remove the speed sensor cable from the rear brake flex hose routing clips.
