Caravan FWD V6-3.3L VIN 3 Flex Fuel (2001)
Fig. 22
2. Using a trim stick or another suitable wide flat bladed tool, carefully pry the air exhauster away from the opening in the lower aperture panel until
the snap features release (Fig. 22).
3. Remove the air exhauster from the hole in the lower aperture panel.
INSTALLATION
SHORT WHEELBASE
1. Position the air exhauster to the hole in the lower aperture panel (Fig. 21).
2. Using hand pressure, press the air exhauster into the opening in the lower aperture panel until the snap features are fully engaged.
3. Reinstall the rear fascia onto the body.
LONG WHEELBASE
NOTE: Models with the optional rear heater and air conditioner do not have an air exhauster on the right side of the vehicle, but have a plastic plug
installed in the right lower aperture panel. This plug is installed using the same procedure used to install the air exhauster onto the short wheelbase
model.
1. Position the air exhauster to the hole in the lower aperture panel (Fig. 22).
2. Using hand pressure, press the air exhauster into the opening in the lower aperture panel until the snap features are fully engaged.
3. Reinstall the quarter trim panel onto the inside of the left or right quarter inner panel.
