Caravan FWD V6-3.3L VIN 3 Flex Fuel (2001)
4. Install booster input rod on brake pedal pin and install a NEW retaining clip.
CAUTION: Do not reuse the original brake lamp switch. The switch can only be adjusted once. That is during initial installation of the switch. If
the switch is not adjusted properly or has been removed for some service, a new switch must be installed and adjusted.
5. Remove and replace the brake lamp switch with a NEW switch.
6. Install the silencer panel below the steering column.
7. Connect vacuum hose to check valve on power brake booster.
CAUTION: The master cylinder (and its rear seal) is used to create the seal for holding vacuum in the vacuum booster. The vacuum seal on the
master cylinder MUST be replaced with a NEW seal whenever the master cylinder is removed from the vacuum booster. When removing the
vacuum seal from the master cylinder do not use a sharp tool.
8. Using a soft tool such as a trim stick, remove the vacuum seal from the master cylinder mounting flange.
9. Install a NEW vacuum seal on rear mounting flange of the master cylinder.
10. Position master cylinder on studs of booster, aligning push rod on booster with master cylinder piston.
11. Install the two nuts mounting the master cylinder to the booster. Tighten both mounting nuts to a torque of 25 Nm (225 inch lbs.).
12. Connect wiring harness connector to brake fluid level switch in the master cylinder fluid reservoir.
13. Connect primary and secondary brake tubes to Antilock Brake System (ABS) Integrated Control Unit (ICU) or non-ABS junction block. Tighten
the tube nuts to 17 Nm (145 inch lbs.).
14. Install wiper module (unit).
15. If equipped with speed control, install speed control servo and connect wiring connector. Tighten the mounting nuts to a torque of 14 Nm (124
inch lbs.).
16. Install the battery tray. Install the two nuts and one bolt attaching the battery tray to the vehicle. Tighten the bolt and nuts to a torque of 14 Nm
(124 inch lbs.).
