Caravan FWD V6-3.3L VIN 3 Flex Fuel (2001)
Fig.10 Rubber Grommet - Typical
6. Push the rubber grommet on the blower motor wire harness through the hole in the lower intake air housing.
7. Feed the blower motor electrical connector through the grommet hole in the lower intake air housing.
8. Position the recirculation air door as necessary to access and remove the three screws that secure the blower motor to the blower housing in the
lower half of the HVAC housing.
Fig.11 Blower Motor Mounting Tabs
9. Gently flex the recirculation-air door far enough to remove the blower motor and blower wheel from the blower housing in the lower half of the
HVAC housing.
10. Remove the blower motor and blower wheel from the vehicle.
INSTALLATION
1. Gently flex the recirculation-air door far enough to position the blower motor and blower wheel into the blower housing in the lower half of the
HVAC housing.
2. Install the three screws that secure the blower motor to the blower housing in the lower half of the HVAC housing. Tighten the screws to 2 Nm (17
in.lbs).
3. Feed the blower motor wire connector through the grommet hole in the lower intake air housing and seat the rubber grommet.