Caravan FWD V6-3.3L VIN 3 Flex Fuel (2001)
Blower Motor Resistor: Service and Repair
Rear
REMOVAL
WARNING: THE BLOWER MOTOR RESISTOR MAY GET VERY HOT DURING NORMAL OPERATION. IF THE BLOWER
MOTOR WAS TURNED ON, WAIT FIVE MINUTES TO ALLOW THE BLOWER MOTOR RESISTOR TO COOL BEFORE
PERFORMING DIAGNOSIS OR SERVICE. FAILURE TO TAKE THIS PRECAUTION CAN RESULT IN PERSONAL INJURY.
CAUTION: Do not operate the blower motor with the blower motor resistor removed from the circuit. Failure to take this precaution can result in
vehicle damage.
1. Disconnect and isolate the battery negative cable.
2. Remove the right quarter trim panel and right D-pillar trim panel from the quarter inner panel. Refer to: "Body and Frame : Interior Trim :
Service and Repair" See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair
Fig.8 Blower Motor Resistor
3. Disconnect the rear HVAC wire harness connector for the blower motor resistor from the resistor connector receptacle.
4. Remove the two screws that secure the blower motor resistor to the rear heater-A/C unit housing.
5. Remove the blower motor resistor from the rear heater-A/C unit housing.
INSTALLATION
CAUTION: Do not operate the blower motor with the blower motor resistor removed from the circuit. Failure to take this precaution can result in
vehicle damage.
1. Position the blower motor resistor into the rear heater-A/C unit housing.
2. Install and tighten the two screws that secure the blower motor resistor to the rear heater-A/C unit housing. Tighten the screws to 2 Nm (17 in.
