Caravan FWD V6-3.3L VIN R (2001)
Ball Joint: Service and Repair
REMOVAL-BALL JOINT SEAL BOOT
1. Remove steering knuckle from vehicle.
2. Using a screw driver or other suitable tool, pry the seal boot off of the ball joint.
INSTALLATION-BALL JOINT SEAL BOOT
1. Place a liberal dab of Mopar(R) Wheel Bearing Grease around the base of the ball joint stem at the socket.
2. Install a NEW seal boot by hand as far as possible on the ball joint. Installation of the seal boot is to be with the shield positioned as shown.
CAUTION: Do not use an arbor press to install the sealing boot on the ball joint. Damage to the sealing boot will occur if excessive pressure is
applied to the sealing boot when it is being installed.
