Caravan FWD V6-3.3L VIN R (2001)
5. If the pivot bearing has been removed form the upper seat, install the pivot bearing on the top of the upper spring seat. The bearing must be
installed on upper seat with the smaller diameter side of the pivot bearing toward the spring seat. Be sure the pivot bearing is sitting flat on the
spring seat once mounted.
6. Install the spring isolator on the lower spring seat of the strut.
7. Install the jounce bumper on the strut shaft. The jounce bumper is to be installed with the small end pointing downward.
8. Install the dust shield on the strut. Collapse and stretch the dust shield down over the top of the jounce bumper until the dust shield snaps into the
slot on the jounce bumper. The jounce bumper will be at the top of the inner dust boot. Return the dust shield to its fully extended length.
