Caravan FWD V6-3.8L VIN L (1999)
7. Using a hammer and Installer Piston Caliper Boot, Special Tool C-4689 and Handle, Special Tool C-4171, drive boot into counterbore of the
caliper.
8. Install guide pin sleeves and bushings.
9. Install brake pads.
10. Before installing caliper assembly on vehicle, inspect brake rotor. If the rotor does not require any servicing, install caliper assembly.
11. Install brake hose onto caliper using banjo bolt. Torque the brake hose to caliper assembly banjo bolt to 33 Nm (24 ft. lbs.). New seal washers
must always be used when installing brake hose to caliper.
12. Bleed the brake system.
Guide Pin Bushing Service
The double pin caliper uses a sealed for life bushing and sleeve assembly. If required this assembly can be serviced using the following procedure.
REMOVING CALIPER GUIDE PIN BUSHINGS
1. Remove caliper from brake rotor. Hang caliper assembly on a wire hook away from the brake rotor.
Removing Inner Sleeve From Bushing
