Caravan FWD V6-3.8L VIN L (1999)
Front Park Brake Cable At Floor Pan
8. Lift floor mat for access to park brake cable and floor pan. Pull the seal and the park brake cable out of the floor pan of vehicle.
9. Pull parking brake cable strand end forward and disconnect button from clevis. Tap cable housing end fitting out of pedal assembly bracket.
10. Remove cable retainer from the parking brake lever (pedal) assembly bracket.
11. Pull front parking brake cable assembly out of vehicle through hole in floor pan.
INSTALLATION
1. Pass front parking brake cable assembly through hole in floor pan from the inside of the vehicle.
2. Pass cable strand button through the hole in the lever (pedal) assembly bracket.
3. Install cable retainer onto the park brake cable and then install cable retainer into pedal assembly bracket.
4. Install the end of the park brake cable into the retainer previously installed into the park brake pedal bracket.
5. Install cable strand button into the clevis on the park brake pedal mechanism.
6. Install the front park brake cable floor pan seal into hole in floor pan. Seal is to be installed so the flange on the seal is flush with the floor pan.
Fold carpeting back down on floor.
7. Raise vehicle.
8. Insert brake cable and housing into body outrigger bracket making certain that housing retainer fingers lock the housing firmly into place.
9. Manually reset the automatic self-adjusting mechanism tension of the parking brake lever (pedal) assembly.
10. Assemble the park brake cables onto the park brake cable equalizer.
11. Lower vehicle and apply the park brake pedal 1 time. This will seat the parking brake cables.
