Caravan FWD V6-3.8L VIN L (1999)
16.
Disconnect the wiring harness connectors from the clockspring assembly (Figure 4).
17.
Remove the clockspring from the multi-function switch by depressing the two tabs on the clockspring (Figure 5). Discard the clockspring
assembly.
18.
Slide the new clockspring over the steering column shaft until the clockspring latches engage the multi-function switch housing (Figure 5).
19.
Connect the wire harness connectors to the clockspring assembly (Figure 4).
20.
Install the upper and lower shrouds onto the steering column (Figure 3). Tighten the screws securely.
21.
Install the steering wheel onto the steering column shaft.
22.
Install the steering wheel damper (if equipped).
23.
Install the steering wheel retaining nut. Tighten the nut to 45 ft-lbs (61 N.m).
24.
Connect the clockspring wire harness connectors to the speed control switches and steering wheel mounted radio controls (if equipped) (Figure 2).
25.
Connect the clockspring airbag wire harness connector to the back of the airbag module (Figure 2).
26.
Connect the clockspring horn switch wire harness connector to the horn switch wire connector on the back of the airbag module (Figure 2).
27.
Install the airbag module onto the steering wheel. Make sure that the clockspring wire harnesses in the steering wheel hub area are not pinched
