Caravan FWD V6-3.8L VIN L (1999)
Separating Ball Joint Stud From Steering Knuckle
15. Using a pry bar, separate steering knuckle from ball joint stud. Note: Use caution when separating ball joint stud from steering knuckle, so ball
joint seal does not get cut.
NOTE: Care must be taken not to separate the inner C/V joint during this operation. Do not allow driveshaft to hang by inner C/V joint after
removing outer C/V Joint from the hub/bearing assembly in steering knuckle, end of driveshaft must be supported.
Steering Knuckle Separation From Driveshaft
16. Pull steering knuckle assembly out and away from the outer C/V joint of the driveshaft assembly.
CAUTION: The steering knuckle to strut assembly attaching bolts are serrated and must not be turned during removal. Remove nuts while holding
bolts stationary in the steering knuckles.
