Challenger V6-3.5L (2009)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper Fascia - Removal
REMOVAL
1. Raise and support the vehicle.
2. Remove the left and right front splash shields as necessary See: Fender/Front Fender/Front Fender Liner/Service and Repair/Splash Shield -
Removal.
3. Remove the belly pan.
4. Remove the mounting fasteners that secures the front fascia assembly (9) to the inside of the front fender.
5. Partially lower the vehicle and remove the push-pin retainers (10) that secure the front fascia assembly to the upper radiator support.
6. Disconnect the Tire Pressure Monitoring (TPM) connector See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire
Pressure Module/Service and Repair/Tire Pressure Monitoring (TPM) Module - Removal.
7. Carefully pull the left and front side of the fascia out of the fender mounted fascia mounting brackets.
8. Carefully pull the front fascia assembly forward to disengage the push-pin retainer from the slot in each side of the fascia and disconnect the fog
lamp wire harness connectors, if equipped.
