Challenger V6-3.5L (2009)
NOTE: Prior to using Special Tool 9520, lubricate Bolt (1) threads to provide ease of use and promote tool longevity.
NOTE: When installing Thrust Bearing (6), be sure to place hardened side toward Bolt head.
29. Assemble tools (See following list) over bushing as shown.
-
(1) Bolt
-
(2) Nut
-
(3) Washer
-
(4) Receiver 9520-4
-
(5) Remover 9520-3
-
(6) Thrust Bearing
30. While holding Nut (2) from rotating, using hand tools, tighten Bolt (1) until Remover (5) comes in contact with bushing and Receiver (4) sets
squarely against crossmember.
31. Continue to tighten Bolt (1), pressing bushing out of crossmember.
32. Remove tools with bushing.
Front Mount
REMOVAL
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair.
