Challenger V6-3.5L (2009)
6. Insert differential mounting bolt (1) through mount bushing from rear (198 mm axle differential shown in figure. Other axles differ, but similar).
NOTE: Do not install coil springs on spring links at this time.
7. Raise crossmember to body mounting points. As crossmember is raised, align shocks (3) with pockets in spring links. Do not install bolts at this
time.
NOTE: There are four crossmember mounting bolts. Rear mounting bolts (2) are longer than front mounting bolts (3). Do not interchange
mounting bolts.
8. Continue to raise crossmember (1) with jack until crossmember mounting bolts (2 and 3) can be installed. Install left side crossmember mounting
bolts, but not the right side bolts. It is not necessary to tighten bolts at this point.
