Challenger V6-3.5L (2009)
5. Remove banjo bolt (4) connecting flexible brake hose (3) to caliper (1). There are two sealing washers (2) (one one each side of hose fitting) that
will come off when bolt is removed. Discard these washers; install NEW washers on installation.
6. While holding guide pins from turning, remove caliper guide pin bolts (2).
7. Remove brake caliper (1) from brake adapter (3) and pads.
Single Pistion
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Technician Safety Information See: Service Precautions/Vehicle Damage Warnings .
