Challenger V6-3.5L (2009)
4. Install each piston (1), one at a time, into its caliper piston (2) bore, pressing piston down to bottom of bore using hand-pressure. Using a piece of
wood or wooden hammer handle may also suffice as long as piston and boot damage is avoided.
CAUTION: When seating dust boots in following step, use care not to over-install boots or damage will occur. Each boot (2) will bottom in the
counterbore before the top of the boot reaches the surface of the caliper. The boot will bottom with approximately 2 mm (1/16
inch) (3) of boot still showing above caliper housing.
5. Seat dust boots (3) in caliper counterbores using Installer 9315 (2) with Handle C-4171 (1). Install each dust boot until it bottoms. Do not
over-seat dust boot or damage will occur.
