Challenger V6-3.5L (2009)
5. Disconnect the wiring harness connector (4) from the brake fluid level sensor (2) in the master cylinder brake fluid reservoir (1).
6. Disconnect the primary (3) and secondary (2) brake tubes from the master cylinder (4). Install sealing plugs in the open brake tube outlet ports.
CAUTION: Before removing master cylinder from power brake vacuum booster, master cylinder and vacuum booster must be thoroughly
cleaned. This must be done to prevent dirt particles from falling into power brake vacuum booster. Use only Mopar(R) Brake
Parts Cleaner or equivalent.
7. Remove the two nuts (2) attaching the master cylinder (3) to the power brake booster (1).
8. Slide the master cylinder (3) straight out of the power brake booster (1).
