Challenger V6-3.5L (2009)
3. Insert opposite end of cable (2) through rear knuckle (3) and install mounting screw (4). Tighten screw to 8 Nm (71 in. lbs.) torque.
4. Install shoe actuator lever (1) on end of parking brake cable (2). Make sure actuator lever is positioned with word "UP" facing outward.
5. Install parking brake shoes as well as all components necessary to access them. See: Parking Brake Shoe/Service and Repair/Installation
NOTE: Due to short travel and low spring tension, it is not necessary to lock out parking brake lever to service parking brake components.
6. Connect rear parking brake cable at equalizer/front cable as follows:
-
If installing left rear cable, connect cable (1) at equalizer (2) above rear axle differential (not shown) and rear crossmember (6).
-
If installing right rear cable, connect cable (4) at connector (3) above rear axle differential (not shown) and rear crossmember (6).
