dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Procedures|Page 2397 > < Procedures|Page 2395
Page 5
background image

3. Coolant leaks: If the pump primary weep passage is plugged, coolant may come from the secondary weep passage and collect in the valley of the

engine. The coolant will eventually run out the back side of the engine. Leakage from the secondary weep passage may give false indications that
core plug(s) may be leaking on the back side of the engine block. If this condition is found, clean the primary weep passage of debris.

NOTE: It is normal for the water pump to weep a small amount of coolant from the primary weep hole (black stain at weep passage). Do not

replace the water pump if this condition exists. Replace the water pump if a heavy deposit or a steady flow of engine coolant is evident
from the primary weep passage. This indicates a shaft seal failure and pump must be replaced. Coolant may leak from the secondary
weep passage and fill the valley of the engine. If this condition is found, clean the primary weep passage of debris. Be sure to perform
a thorough analysis before replacing water pump.

4. Impeller rubs inside of cylinder block.
5. Excessively loose or rough turning bearing.

Procedures|Page 2397 > < Procedures|Page 2395