Challenger V6-3.5L (2009)
REMOVAL
1. Remove the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Removal.
2. Remove the retainer (3) that secures the floor console duct (2) to the center floor panel (4).
3. Disconnect the floor console duct from the floor distribution duct (1) and remove the console duct from the vehicle.
Floor Console Duct - Installation
INSTALLATION
1. Position the floor console duct (2) into the vehicle.
2. Connect the floor console duct to the floor distribution duct (1).
3. Install the retainer (3) that secures the floor console duct to the center floor panel (4).
4. Install the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation.
Floor Distribution Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
FRONT FLOOR DISTRIBUTION DUCT
