Challenger V6-3.5L (2009)
Blower Motor Resistor: Service and Repair
Installation
INSTALLATION
1. Position the blower motor resistor (2) into the HVAC housing (3).
2. Install the two screws (1) that secure the blower motor resistor to the HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the wire harness connector (4) to the blower motor resistor and engage the locking tab.
4. Install the glove box into the instrument panelSee: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument
Panel Glove Box - Installation.
5. Reconnect the negative battery cable.
