Challenger V6-3.5L (2009)
Spark Plug Tube: Service and Repair
Installation
INSTALLATION
1. Apply Mopar(R) Stud and Bearing Mount to a new tube (1) approximately 1 mm (0.039 in.) from the end of tube, in a 3 mm (0.118 in.) wide area.
2. Install sealer end of tube (1) into the cylinder head. Then carefully install the tube (1) using a hardwood block and mallet. Install the tube (1) until
it is seated into the bottom of the bore.
3. For spark plug tube (1) seal replacement, See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover/Service and
Repair/Cylinder Head Cover(s) - Removal.
4. Install cylinder head cover(s). See: Engine, Cooling and Exhaust/Engine/Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder Head
Cover(s) - Installation