Challenger V6-3.5L (2009)
4. Lubricate the EGR mounting tube hole in the intake manifold with Mopar(R) Rubber Bushing Installation Lube. Do not lubricate the EGR tube or
seal.
5. Install the EGR tube (3) into the intake manifold (2) being careful not to damage the silicone rubber seal, and verify that the seal is correctly
positioned in the intake manifold.
6. Install a new gasket between the EGR valve (3) and the EGR tube. Install the bolts (1) and tighten to 15 Nm (11 ft. lbs.).
NOTE: The EGR tube flange (1) does not need to be flush with the intake manifold (2) to be sealed. The EGR tube flange can be up to 2 mm
(0.08 in.) from intake manifold and still be sealed. This design allows the EGR tube position to vary with the tolerance stack up and
remain properly sealed.
