Challenger V6-3.5L (2009)
8. Scroll down and select the "Cam Crank Synchronization Event Monitor
9. Scroll down and read both the "Engine Unlock Position" and the "Unlock RPM" status.
10. Is the "Engine Unlock Position between 40 and 55 or 400 and 415 degrees with the "Unlock RPM greater than 3000 RPM??
a. Yes >>> proceed to Step # 18
b. No >>> Perform a "Module Reset" with wiTECH and "TLC Relearn" with wiTECH.Repair Complete.
11. Connect wiTECH to vehicle if not connected.
12. Select PCM.
13. Select the "Monitor List" tab.
14. Scroll down and select the "Cam Crank Synchronization Event Monitor"
15. Scroll down and read both the "Engine Unlock Position and the "Unlock RPM" status.
16. Is the "Engine Unlock Position" between 40 and 55 or 400 and 415 degrees?
a. Yes >>> proceed to Step # 17
b. No >>> This Bulletin does not apply. Refer to the Diagnostic Procedure available in DealerCONNECT/TechCONNECT for P0339 - Crankshaft
Position Sensor Intermittent to diagnose this condition.
17. Is the "Unlock RPM" greater than 3000 rpm?
a. Yes >>> proceed to Step # 18
b. No >>> Refer to the Diagnostic Procedure available in DealerCONNECT/TechCONNECT for P0339 - Crankshaft Position Sensor Intermittent
to diagnose this condition.
18. Remove the crankshaft position sensor. Follow the detailed service procedures available in DealerCONNECT/TECHCONNECT, Refer to 14 - Fuel
System / Fuel Injection / SENSOR, Crankshaft Position / Removal.
19. Install washer (p/n 68061031aa) between sensor fastener bushing and transmission.
20. Reinstall the crankshaft position sensor.
21. Perform a "Module Reset" with wiTECH.
22. Perform a "TLC Relearn" with wiTECH..
NOTE:
It is necessary to perform a "Module Reset and TLC Relearn" prior to driving the vehicle. If this step is not preformed the values will not be
accurate. The values need to be reset.
23. Drive vehicle and perform 6 to 8 wide open throttle 1-2 shifts in the 5,800 RPM range.
24. Connect wiTECH to vehicle.
25. Select PCM.
26. Select the "Monitor List" tab.
27. Scroll down and select the "Cam Crank Synchronization Event Monitor"
28. Scroll down and read both the "Engine Unlock Position" and the "Unlock RPM" status.
29. Is the "Engine Unlock Position between 40 and 55 or 400 and 415 degrees with the "Unlock RPM greater than 3000 RPM??
a. Yes >>> proceed to Step # 30
