Challenger V6-3.5L (2009)
6. Connect the electrical connectors at the top of the fuel pump module.
7. Join the upper and lower halves of the fuel pump module together.
8. Position the fuel pump module in the fuel tank.
CAUTION: An indexing arrow is located on top of the fuel pump module to clock it's position into the fuel tank. The fuel pump module must
be installed in the same position as removed.
9. Align the rubber O-ring seal and lower the fuel pump module into position.
10. Position the lock-ring over top of the fuel pump module.
11. Rotate the fuel pump module until the embossed alignment arrow points to the center alignment mark or the same position as noted during
removal. This step must be performed to prevent the float from contacting the side of the fuel tank.
12. Install the lock-ring remover/installer 9340 (1) into the notches on the outside edge of the lock-ring.
13. Install a 1/2 inch drive breaker bar into the lock-ring remover/installer 9340 (1).