Challenger V6-3.5L (2009)
7. Position transmission cooler line (2) and install transmission cooler line clamp bolt (1) to right crossmember (3).
8. Install middle splash shield.
9. Lower vehicle.
CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the
wrong direction if the belt is installed incorrectly, causing the engine to overheat.
10. Install drive belt, See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Removal and Replacement/Serpentine Accessory Drive Belt - Installation.
11. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
