Challenger V6-3.5L (2009)
6.
Push the sidewall of the tire down at the sensor and place two small blocks of wood between the tire and rim (Figure 2).
7.
Remove sensor nut that retains the sensor to the wheel.
8.
Carefully remove the sensor from the wheel.
9.
Wipe area clean around sensor/valve stem mounting hole in wheel.
10.
Insert the sensor through the wheel keeping pressure against rear of metal valve stem. The potted side of sensor is to be positioned toward wheel.
11.
Install the sensor nut by hand.
CAUTION:
Before tightening the sensor nut, push downward on the sensor housing so it is flush with interior contour of wheel.
12.
While holding sensor in position, tighten sensor nut to 71 in. lbs. (8 N.m) (Figure 3)
CAUTION:
Over-tightening the sensor nut may result in sensor separation from the valve stem.
13.
Remove the two wood blocks from between the wheel and tire (Figure 2)
14.
Inflate the tire to seat the tire bead to the rim.
15.
Adjust air pressure to that listed on the Tire Inflation Pressure Label (Placard) provided with vehicle (located on the driver's side B-pillar).
