Challenger V6-3.5L (2009)
Stabilizer Bar: Service and Repair
Rear Suspension Stabilizer Bar - Installation
INSTALLATION
1. Install isolators on stabilizer bar utilizing slits in bushings. Install each isolator so its slit faces forward and flat side is positioned toward
crossmember once installed.
2. Install retainers on isolators.
3. Install stabilizer bar (4) with isolators and retainers on crossmember.
4. Install isolator retainer mounting bolts (1). Do not tighten at this time.
5. Install bolt (3) and nut fastening stabilizer bar ends to each stabilizer links (2). Do not tighten at this time.
6. Tighten isolator retainer mounting bolts (1) to 61 Nm (45 ft. lbs.).
7. Remove coil springs (2) with isolators (1 and 5) from spring links (4).
8. Raise crossmember to body mounting points. As crossmember is raised, slide propeller shaft onto rear axle differential flange and align shocks
with pockets in spring links.
