Challenger V8-5.7L (2010)
f.
Verify the windows are properly calibrated by operating the "Auto-Up" feature on the windows. Repeat this procedure if the calibration failed.
25. For Vehicles equipped with Electronic Stability Program (ESP), calibrate the Steering Angle Sensor (SAS) using the following procedure:
CAUTION:
If the vehicle is equipped with Electronic Stability Program (ESP), once the battery is reconnected, the Steering Angle Sensor (SAS) within the
Antilock Brake Module (ABM) needs to be calibrated. The SAS requires calibration (initialization) using the wiTECH scan tool. If the SAS is
not calibrated following battery reconnection, the ESP/BAS indicator lamp will flash continuously with no Diagnostic Trouble Codes (DTC's).
a. Position the front wheels straight ahead and center the steering wheel.
b. Connect the wiTECH pod to the vehicle data link connector.
c. Place the ignition in the "RUN" position.
d. Launch the wiTECH Diagnostic Application.
e. Starting at the "Vehicle View Screen" screen, select "ABS Icon".
f.
Select the "Misc. Functions" tab.
g. Select "Initialize ECU" from the list.
h. Follow the wiTECH on-screen instruction to complete the drive test.
26. For Vehicles equipped with Electronic Stability Program (ESP), clear all Diagnostic Trouble Codes (DTC's)
27. Disconnect and remove the wiTECH pod from the vehicle.
28. Reset the clock located in the radio.
